Reply to thread

Message: [QUOTE="CrewCab7.3, post: 562886, member: 8479"] I started up the truck earlier and let it idle for a while. It was blowing a little white smoke, but it's been doing that since the problems started but it clears up after I start driving. After a couple minutes the throttle pedal wouldn't work and was blowing even more white smoke. After about 10 seconds it started working again and the smoke cleared up. After it ran for about 30 minutes I took the temp gun to check the manifold temp on each cylinder. The number 8 is a lot colder than the others. I had the same issue a few weeks ago and after checking all the injectors the number 8 had a broke armature screw, I replaced it and the injector started working again but the motor was still cutting out around 1800 rpms and up. I drove the truck for a long time with the number 8 not working before and it ran fine up until recently. When I first started having these problems it started with the gas pedal not working and white smoke everywhere while I was driving. It ran fine for a few days and now I'm having these issues. [/QUOTE]

Verification

Random media

Frosty 6.7

factory 20's with 35x12.50r20 toyo mt

baja_rack_1_PIC

1511MG-100

MSGR_PHOTO_FOR_UPLOAD_1540210354297_jpg_1540210357886

Glow Plugs

he351ve T4i turbine inlet

phone_pics_099

he451ve turbine

Latest posts

S
6R140 surging issue
- Latest: Smokin 6.0
- Today at 12:26 PM
6.7 Tech & FAQ
Won’t start
- Latest: psduser1
- Wednesday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Jun 6, 2025
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Jun 5, 2025
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Jun 5, 2025
6.0 Tech

Members online

No members online now.

Total: 267 (members: 0, guests: 267)

Top