Reply to thread

Message: [QUOTE="TexasJ, post: 1529972, member: 30660"] Hi guys, I am replacing the ac compressor, condensor, dryer, evaporator, and all Orings lines and hoses on my 96 F250. After I do this I plan on driving it to my mechanic to have him charge the system properly. My question is: will it damage the compressor or any of the new components if I install everything and then drive it without any freon or pag oil in the lines? If so, can this be avoided by disconnecting the electrical pigtail from the compressor? Or perhaps by leaving one of the hoses disconnected for air to escape? I don't want to risk putting all these new parts in only to have them get destroyed by driving 5 miles without fluid in the system. [/QUOTE]

Verification

Random media

Screen_shot_2012-01-29_at_8_36_53_AM

My new platinum all stock besides that cop tint

New grille

Fork_no_gap

IMAG0012

IMAG0203-1

100_2108

P2230001

Capone truck short bed

Latest posts

Truck slipping into 4th
- Latest: Sterling6.7
- Yesterday at 7:18 PM
6.7 Tech
Do not recommend Choate Engineering
- Latest: DEEZUZ
- Wednesday at 10:22 PM
Newly Enlisted
A few turbo questions and a rant
- Latest: ghohouston
- Wednesday at 9:41 PM
7.3 Aftermarket
O
2011-2016 Radiator upgrade
- Latest: OtisCreekConstruction
- Wednesday at 6:17 PM
6.7 Tech
Performance shops
- Latest: DEEZUZ
- Tuesday at 8:42 AM
7.3 Performance

Members online

No members online now.

Total: 880 (members: 0, guests: 880)

Top