Reply to thread

Message: [QUOTE="TARM, post: 295261, member: 578"] You can or not. But if you do it it would likely save you a ton of time to borrow a 3/4" -1" drill (large) rent it if need be and then buy a large hole saw bit the right size and use that to cut the plating. Just an idea. The other way is to trace the circle cut line and then drill a ton of holes and finish it up with a angle grinder. Heck even a dremel with a stone while taking a while would get it done to smooth out the edge from the cut. It up to you whether to run the sump or not. If I was going to I would get some plate or weld some rigid pipe to the tank plate to run the hose thru to protect it. [/QUOTE]

Verification

Random media

PART_1421341331249_20150115_105835

My 6oh

Pfm

25634_1295950922276_1335447039_30951808_1247213_n

My 6oh

IMAG0668

110321_133033

11-8-2014

P5270124

20121111_180106

IMAG0331

Latest posts

6R140 surging issue
- Latest: Sterling6.7
- Today at 10:52 PM
6.7 Tech & FAQ
Won’t start
- Latest: psduser1
- Wednesday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Jun 6, 2025
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Jun 5, 2025
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Jun 5, 2025
6.0 Tech

Members online

Smokin 6.0

Total: 406 (members: 1, guests: 405)

Top