Reply to thread

Message: [QUOTE="gman1, post: 250404, member: 783"] OK here you go: Support the axle housing with a floor jack and remove the front shocks. The shocks are limiting droop so make sure the axle is supported or the axle will fall when the shocks are removed. Loosen the 24mm nut on the lower end of the pan rod bar; leave the nut engaged a couple a threads. Put a pry bar between the pan rod bar and the lower pan rod joint housing. Slowly lower the axle housing making sure not to over extend any hoses or brake lines, as the axle is lowered the pry bar will cam in-between the joint and dislodge the taper. You will hear a loud pop when the taper dislodges. You can now remove the nut and the upper pan rod bar. This worked great for me per the instructions. [/QUOTE]

Verification

Random media

sept_29_10_171

6637 and 3" DP

EGT, boost, fuel PSI

baja_rack_PIC_

photo-4

2013-02-04_13-16-43_486

983C27CB-9ADA-4E33-B2DF-80CBFF8A98BF

Wayne_04

Latest posts

Truck slipping into 4th
- Latest: Sterling6.7
- Yesterday at 7:18 PM
6.7 Tech
Do not recommend Choate Engineering
- Latest: DEEZUZ
- Wednesday at 10:22 PM
Newly Enlisted
A few turbo questions and a rant
- Latest: ghohouston
- Wednesday at 9:41 PM
7.3 Aftermarket
O
2011-2016 Radiator upgrade
- Latest: OtisCreekConstruction
- Wednesday at 6:17 PM
6.7 Tech
Performance shops
- Latest: DEEZUZ
- Tuesday at 8:42 AM
7.3 Performance

Members online

No members online now.

Total: 621 (members: 0, guests: 621)

Top