Reply to thread

Message: [QUOTE="mandkole, post: 834779, member: 4630"] A little more searching-- The PCM runs (good signal/data on the scan gauge). Ive also noted that they gauges do not 'home', which according to Isspro is a voltage issue. I've disconnected both batteries to reset the PCM--with some of the accys not getting good power, it acts like its in limp mode (just a theory). I fully cleaned the terminals (not dirty, but one batt had begun to boil over). Another noted issue was that I charged the batts individually and the pass side batt (with the boil over), was trying to take close to 15.6V-- Ive [U]never[/U] seen a healthy battery on a 10A charger take that level of charge. Im going to likely kick these to the curb and get the Dekas that Ive had in everything I've owned for the past 10 years. [/QUOTE]

Verification

Random media

IMAG0028

ms4

08 bucket seat panel trim

gopro

467

08 door sill

joestruck4

RSK

20161028_080729

Latest posts

Won’t start
- Latest: psduser1
- Yesterday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Friday at 1:24 PM
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Jun 5, 2025
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Jun 5, 2025
6.0 Tech
T
2013+ steering gearbox in older trucks
- Latest: TPOLO
- Jun 4, 2025
Suspension, Drive Train, and Tires

Members online

No members online now.

Total: 299 (members: 0, guests: 299)

Top