Reply to thread

Message: [QUOTE="Corb@CorbinShipping, post: 1415787, member: 2499"] Still making assumptions, huh? People like you, make me laugh. The bed has been off before, in fact, taken off by the same company, yet a different shop. the CCV does not need to be touched, and it is routed under the frame, into the exhaust. the end of the hose, was disconnected, from the exhaust, zipties were cut, and the hose was layed over the top of the frame, and the bed places, perfectly on top of it.... A blind man, could take the 8 bed bolts out, and the three screws holding the fuel hose in place, and the few other support bolts, and remove the bed. and unless you reach UNDER THE FRAME, DISCONNECT THE END OF THE CCV FROM THE EXHAUST, CUT 3 ZIP TIES, RE ROUTE THE CCV HOSE OVER THE FRAME, LAY IT THERE, AND DROP THE BED DIRECTLY ON IT, then this would never have been an issue, and I would have driven my truck home... But thanks for being a complete panty waste of an excuse for a human being, and mucking up this thread, with your wisdom and assumptions, based on less that the facts. You can dismiss yourself, as I give less that two ****z about you, or your bull ****. It's funny to me, that I get invited to $10,000 dinners, and flown around the world, just to motivate folks, and speak to disabled veterans, special operations guys, police, and kids who have had a rough time with their disabilities or injuries. I have met hundreds of guys off of this site, and others (even the chevy and dodge guys) and get along famously with them. Yet you decided that I am beneath you? LOL You continuously "poke the bear" and then try to prove how much smarter you are.. Good luck in your future endeavors, and kindly, **** off... [/QUOTE]