Reply to thread

Message: [QUOTE="ArmyPilot, post: 1254517, member: 22049"] You have to do a couple "drive cycles" to get all the monitors to read "ready". Check your owners manual for the specific procedure but it should be similar to this: Ford: Newer Ford owner’s manuals include a drive cycle, which is as follows: The OBD-II system is designed to check the emission control system during normal driving. A complete check may take several days. If the vehicle is not ready for E-Check testing, the following driving cycle consisting of mixed city and highway driving should be performed: 15 minutes of steady driving on an expressway/highway followed by 20 minutes of stop-and-go driving with at least four 30-second idle periods. Allow the vehicle to sit for at least eight hours without starting the engine. Then, start the engine and complete the above driving cycle. The engine must warm up to its normal operating temperature. Once started, do not turn off the engine until the above driving cycle is complete. If the vehicle is still not ready for E-Check testing, the above driving cycle will have to be repeated. You'll have to start over since you unhooked your batteries. Good luck!! [/QUOTE]

Verification

Random media

2011-12-18_16-44-01_291

0091

eleanor_part_two_70_

DAY_TWO_2_

Duramax hauling cattle

secret_lab_2

20200513_190858

excursion the 250 and the wife

2008 King Ranch motor work

the 89 and the 08

Latest posts

Truck slipping into 4th
- Latest: Sterling6.7
- Yesterday at 8:29 PM
6.7 Tech
Do not recommend Choate Engineering
- Latest: DEEZUZ
- Wednesday at 10:22 PM
Newly Enlisted
A few turbo questions and a rant
- Latest: ghohouston
- Wednesday at 9:41 PM
7.3 Aftermarket
O
2011-2016 Radiator upgrade
- Latest: OtisCreekConstruction
- Wednesday at 6:17 PM
6.7 Tech
Performance shops
- Latest: DEEZUZ
- Tuesday at 8:42 AM
7.3 Performance

Members online

LivinAnAdvntr

Total: 529 (members: 2, guests: 527)

Top