Reply to thread

Message: [QUOTE="windrunner408, post: 296866, member: 1868"] Nevermind. I thought about this some more and dont think it will work as there is no doubt not enough room in the cam shaft channel to pull the lifters out so if I wanted to replace my lifters, I would have to pull the heads. I am confident that the push rods can be replaced by not pulling the heads as long as they are replaced with torquing the headstuds back down after each pushrod is replaced. [/QUOTE]

Verification

Random media

2008 6.4L pic13

2.5" in front,4" rear. 35x12.5x17's.

installed1

rear_axle_10_

Sump

122710_066

Latest posts

6R140 surging issue
- Latest: Sterling6.7
- Yesterday at 10:52 PM
6.7 Tech & FAQ
Won’t start
- Latest: psduser1
- Wednesday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Jun 6, 2025
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Jun 5, 2025
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Jun 5, 2025
6.0 Tech

Members online

No members online now.

Total: 215 (members: 0, guests: 215)

Top