Reply to thread

Message: [QUOTE="sandpiperx, post: 1179107, member: 18713"] hand threaded the bottom piece drilled the hole on the intake 1/8 smaller in the elbow. The material has some give and take. SO it fit really snug once slid through. rtv through out and cured for 2 days I found a plastic bolt at a ace hardware and tightened on the inside. I really do not need the thin bolt on the inside. The seal on the fitting and rtv was quite thorough enough in my opinion and held the piece in check so far. this all came out of the blue so I am watching and testing as I go to make sure everything holds as hoped. I just wanted to make sure that I used one inch hose to keep the pressure moving with little or no restriction. I am by no means a part maker just was kinda of a hobby thing for me and see if it would work. SO far pretty darn good. hope this helps. m [/QUOTE]

Verification

Random media

DSC06940b

I was tired of the damn chrome!

IMAG1090

Dash locations for custom gauge pod

My 6.4s

RSK

317365_166563960102974_100002481131528_318921_78460406_n

photo_32

transmission_pic_2_2_

Misc_038

Broken RV Frame

Latest posts

I must be getting old… Exhaust is too loud
- Latest: Derkperk
- Today at 2:18 PM
6.0 Aftermarket
T
B&W hitch and shock removal
- Latest: TexMac
- Wednesday at 2:48 PM
2017+ 6.7 Aluminum Super Duty
6
ISSUES WITH CHOATES WARRANTY
- Latest: 6.7powersmoke
- Wednesday at 2:12 PM
1999-2015 Superduty Series General
Truck slipping into 4th
- Latest: Sterling6.7
- Apr 25, 2025
6.7 Tech
Do not recommend Choate Engineering
- Latest: DEEZUZ
- Apr 23, 2025
Newly Enlisted

Members online

Total: 615 (members: 2, guests: 613)

Top