Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
New showcase items
New showcase comments
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Showcase
New items
New comments
Latest content
Latest reviews
Latest updates
Search showcase
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Power Strokes
7.3 Tech
Cruise control problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="BigAlsPSD, post: 427179, member: 2220"] Clutch Pedal Position Sensor there are springs inside them that are known to break. Replacement from parts stores is only around 25 bucks. First remove the switch from the actuator rod. (hard to get to and I couldn't get a camera in there to get a pic, sorry) There's a large plug in the top with several wires but the only hard part is getting your hand in position so you can get the screwdriver or knife blade to it. After removing the plug pull the switch backwards just enough so it will rotate on the rod. When you rotate the top towards you there is room to get a screwdriver or knife blade to the flat tabs on either side, when you pry the tabs up the bottom of the switch will come off easily. Here is a pic of the switch. [ATTACH]9268._xfImport[/ATTACH] Inputs to your cruise control are Brake Pedal Position Switch Clutch Pedal Position Switch(CPP) Brake PRESSURE switch Clock spring to coast button has120 ohm resistor Clock spring to set/accel button has 680 ohm resistor Clock spring to Resume button has 2200 ohm resistor Also takes input from VSS signal (ABS module) The ABS module gets input from the Differential Speed Sensor There is a 5 amp fuse at position 15 fro brake pedal There is a 10 amp fuse at position 19 for CPP There is a PCM power relay that feeds into the Brake Pressure Sensor(battery junction box) [/QUOTE]
Insert quotes…
Verification
Post reply
Random media
Latest posts
Won’t start
Latest: psduser1
Wednesday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
Latest: hskfab
Jun 6, 2025
Engine and Drivetrain
Hard steer question/issue
Latest: psduser1
Jun 5, 2025
7.3 Tech
B
WTS/WIF light flash and stall issue
Latest: blickcd
Jun 5, 2025
6.0 Tech
T
2013+ steering gearbox in older trucks
Latest: TPOLO
Jun 4, 2025
Suspension, Drive Train, and Tires
Members online
Kowboy
Forums
Power Strokes
7.3 Tech
Cruise control problem
Top
