Reply to thread

Message: [QUOTE="cbuttre835, post: 430505, member: 1190"] Ok so I have finally gathered parts for my bronco tank swap in my CCSB 97. I dropped the spare tire and removed the two rear skid plate bolts. Very rusty, this truck is. :( Having to do a lot of sawzall work. Bottom of the tank is quite rusty on the outside. Hence my "water in fuel" and rusty fuel bowl woes... I assume I need to remove the three screws holding the filler neck housing to the truck bed, to let that hose drop with the tank. It got dark on me where I couldn't see well. What about the wire and plumbing? What should I take loose before removing the two front bolts / nuts and letting the thing drop to the ground? Or is there enough slack in that assembly? :doh::morons: [/QUOTE]

Verification

Random media

rear_axle_13_

20121013_120023

yates_001

AWOL

IMG_20171206_195951451

silver_truck_carriage_works

2016-02-28_17_14_03

original_eleanor_1_

2008 King Ranch motor work

IMAG0011

Latest posts

10R140 failure
- Latest: Sterling6.7
- Yesterday at 8:54 PM
2017+ 6.7 Aluminum Super Duty
D
Turning off the Auxiliary powertrain control module
- Latest: donaldtfreeman
- Yesterday at 10:43 AM
6.0 Tech & FAQ
4r100 P0715/P0717 trouble codes.
- Latest: Tiha
- Yesterday at 8:07 AM
7.3 Tech & FAQ
I must be getting old… Exhaust is too loud
- Latest: ju015dd
- Sunday at 7:59 AM
6.0 Aftermarket
2000 f350 dually lariat
- Latest: Powerstroke Cowboy
- Saturday at 8:30 PM
7.3 Aftermarket

Members online

No members online now.

Total: 950 (members: 1, guests: 949)

Top