Reply to thread

Message: [QUOTE="Tree Trimmer, post: 20472, member: 716"] you didnt say you had alift pump. that bein the case, you would just use two stockers, like in that pic, without the rest of the stuff. out of your lift pump into whatever line you need to get to the pumps, into a Y block, into the pumps, out to a Y block, into the line to get to the motor. i can only base this next part off a 7.3, but it should apply to your 6.0 make sure you are not using the stock feed line, oversize to accomodate the extra pump. on ours, its -10an hose from tank to pumps, and -8an from pumps to motor, into a Y, to -6an to the heads. you guys use much smaller injectors than we do, so your sizes might be different. [/QUOTE]

Verification

Random media

Side shot before the lift was installed

2011-09-01_17-41-44_703

new wheels for workstock

side-1

New Two Tone

Wheels for sale

100_7141

TheSmokinStroke2002

befor an after

Ben's 96

100_0475

2011-04-20_14-49-24_765

Latest posts

02 F250 7.3 Will crank, WTS stays on, no start, no OBD
- Latest: Sterling6.7
- Sunday at 8:57 PM
7.3 Tech
P0087
- Latest: DEEZUZ
- Sunday at 11:49 AM
6.4 Tech & FAQ
2015-2019 6.7 HPFP New In Box
- Latest: lincolnlocker
- Jun 1, 2026
Engine and Drivetrain
First 6.0L (56k warning)
- Latest: adrianspeeder
- May 26, 2026
6.0 Tech
Extra external motor oil cooler?
- Latest: justinlogue5_0
- May 26, 2026
7.3 Tech

Members online

No members online now.

Total: 7,237 (members: 0, guests: 7,237)

Top