Reply to thread

Message: [QUOTE="old man dave, post: 610023, member: 1009"] The AN-6 fitting is basically 3/8" bore sized. When you look at an AN-6 male fitting there is a flat "shoulder" section between the bored hole and the threaded section. I left about 0.050" width after drilling it out (less than a 1/16"). The fitting uses this section to seal on and my AN-6 fittings sealed up just great with this width of "shoulder" and it did not weaken the fitting (left enough meat for strength). Any good drill set (1/64"ths) will have the bit you can use. Use the modified fuel rail plugs in the rear of the heads then you can use the stock fuel return lines off of the front of the heads as the return lines to the pressure regulator. Mount the pressure regulator at the front of the engine valley or off of the rear of the hpop reservior. RockAuto has tank straps for less than $20 a set. [/QUOTE]

Verification

Random media

sealevelSOI

IMAG0535

pulsewidth

corner

silver_truck_drivers_side_front_house

Mini Maxx

My Baby :)

IMG_20170708_172003003

Latest posts

Truck slipping into 4th
- Latest: Sterling6.7
- Friday at 7:18 PM
6.7 Tech
Do not recommend Choate Engineering
- Latest: DEEZUZ
- Wednesday at 10:22 PM
Newly Enlisted
A few turbo questions and a rant
- Latest: ghohouston
- Wednesday at 9:41 PM
7.3 Aftermarket
O
2011-2016 Radiator upgrade
- Latest: OtisCreekConstruction
- Wednesday at 6:17 PM
6.7 Tech
Performance shops
- Latest: DEEZUZ
- Tuesday at 8:42 AM
7.3 Performance

Members online

No members online now.

Total: 575 (members: 0, guests: 575)

Top