Reply to thread

Message: [QUOTE="smokinstroker92, post: 1322723, member: 3595"] Installed a built trans from a trans shop i use regularly and have never had any issue. The issue that i am having is it will not make the 1-2 shift in Drive. All other shifts are fine but will not make the 1-2 you must rev out in 1st and lift and let it shift straight to 3rd. However if you use the manual 1 and 2 on the column it will shift 1-2 nice and firm like it should. So start in 1 bump it to 2 bam shift, then bump it to drive once rpms get up and bam 3rd. But if you go from 2 to drive before the pcm commands 3rd it will no into nuetral and you have to lift and allow it to shift to 3rd. I have replace the solenoid pack, neutral safety switch, and the solenoid pack wiring pigtail all with no change. Where do i go now? [/QUOTE]

Verification

Random media

2011-08-06_14-26-02_457

pics

My 2000 F250 7.3L and a friends Duramax

Magneto_rear

2011-08-06_15-02-32_811

20200209_165846

phone_pics_11-24-12_228

IMAG1459

Mishi

20140325_095243

MG_6989

Latest posts

Truck slipping into 4th
- Latest: Sterling6.7
- Friday at 7:18 PM
6.7 Tech
Do not recommend Choate Engineering
- Latest: DEEZUZ
- Wednesday at 10:22 PM
Newly Enlisted
A few turbo questions and a rant
- Latest: ghohouston
- Wednesday at 9:41 PM
7.3 Aftermarket
O
2011-2016 Radiator upgrade
- Latest: OtisCreekConstruction
- Wednesday at 6:17 PM
6.7 Tech
Performance shops
- Latest: DEEZUZ
- Tuesday at 8:42 AM
7.3 Performance

Members online

No members online now.

Total: 573 (members: 0, guests: 573)

Top