Reply to thread

Message: [QUOTE="getstuk, post: 1097805, member: 12375"] I just installed my SCT tuner with IDP tunes, also deleted cat + dpf, and no-limit intake. I keep getting REDUCED POWER MODE whenever I go WOT on my "X" tune from IDP. I am headed to Pismo tomorrow and have a lot of money invested into this trip. I am afraid there may not be anything I can do by then :( [B]Data trouble codes that are always on (possibly due to missing EGT sensor):[/B] P0488 (EGR Throttle position control range / performance) P0000 (On Board Diagnostic system readiness test not complete) [B]Data trouble codes that pop up under WOT (reduced engine power):[/B] P244D (Catalyst Temperature too high during regeneration, bank 1) P252F (Engine oil level too high) I have NOT deleted the EGR yet but I'm told to tell my tuning device that I have regardless(!!!), so I have. One of the EGT sensors is stuck inside the DPF so I need to get that out in the morning and plug that back in, I'm hoping that will AT LEAST get rid of the EGR code. Anyone experience this? I will check my engine oil level then too, but I'll only have a few hours to sort this out before I have to tow a trailer and head out to the Pismo dunes. I appreciate your help ahead of time. [/QUOTE]

Verification

Random media

The Truck

'07 5.9 Cummins

misc_2013_111

572

Excursion

0208151604b

IMG_20150506_204959939

Latest posts

Won’t start
- Latest: psduser1
- Yesterday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Friday at 1:24 PM
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Jun 5, 2025
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Jun 5, 2025
6.0 Tech
T
2013+ steering gearbox in older trucks
- Latest: TPOLO
- Jun 4, 2025
Suspension, Drive Train, and Tires

Members online

No members online now.

Total: 168 (members: 0, guests: 168)

Top