Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
New showcase items
New showcase comments
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Showcase
New items
New comments
Latest content
Latest reviews
Latest updates
Search showcase
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Non - Specific
Truck Audio
Fall/winter project
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="Extended Power, post: 1133933, member: 898"] Been working on this since about June, gathering parts and pieces. Coming together nicely. Hope to be complete by late February, early March. Started buying some amps, power cables, and one sub. [ATTACH=full]146514[/ATTACH] JL12W7-3 sub [ATTACH=full]146515[/ATTACH] If one is good...why not run two of them? [ATTACH=full]146516[/ATTACH] What I started with, thanks to a local stereo shop who installed my present system. [ATTACH=full]146517[/ATTACH] Since I needed a lot more room for two 12's, I found a set of like new factory KR buckets, complete with the center console, and all the mounting hardware. (Not using the console.) [ATTACH=full]146518[/ATTACH] Just had to set them in to see what they would look like. [ATTACH=full]146519[/ATTACH] [ATTACH=full]146520[/ATTACH] Then it was time to remove most of the interior and try to control the vibrations. 100% coverage with Dynamat Extreme. [ATTACH=full]146521[/ATTACH] [ATTACH=full]146522[/ATTACH] After there was two layers of the Dynamat Extreme covering the transmission tunnel from the front to the back of the cab, and all the doors had the inside panels covered, it was time to reduce the noises from outside getting in, and the inside noises getting out. [ATTACH=full]146523[/ATTACH] This shows the installation of CCF and MLV on the back wall, which was then covered with a 1/2" thick layer of Dynaliner. [ATTACH=full]146524[/ATTACH] [ATTACH=full]146525[/ATTACH] [ATTACH=full]146526[/ATTACH] [ATTACH=full]146527[/ATTACH] Got the rug back in after I finished the rear doors with the Dynamat Extreme on the inside door skin, (outside panel) inside door panel, and then covered with CCF and MLV. Then I started putting the panel covers back on, but not before I covered them with Dynaliner on the backside. [ATTACH=full]146528[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Random media
Latest posts
New torque converter locking up in Reverse and 1st gear
Latest: 6.0 Tech
Yesterday at 11:12 PM
6.4 Tech
0
Dana 80 cab and chassis rear end
Latest: 03f3507.3
Friday at 2:11 PM
Engine and Drivetrain
Another jack of all trades tire thread
Latest: ToMang07
Friday at 7:28 AM
Suspension, Drive Train, and Tires
B
No Start help
Latest: bismic
Friday at 7:04 AM
6.0 Tech
Compound Turbocharged 6.0L Powerstroke Engine
Latest: 6.0 Tech
Wednesday at 8:24 AM
Ford Power Stroke News
Members online
No members online now.
Forums
Non - Specific
Truck Audio
Fall/winter project
Top