Reply to thread

Message: [QUOTE="AshevilleEngine.com, post: 1567667, member: 11592"] * CLEAN all of the parts that you plan to reuse, inside and out. Manifolds, covers, etc. * You can use a chain attached to the lifting eyes to lift the engine. * Borrow a specialty tool to install front and rear main seals. O'Reilly's, Advance Auto, NAPA and most auto parts stores loan them. * When you install the front cover, make sure that both of the dowels to line it up are between the block and the cover. One is located at the 2:00 position and the other is at 6:00 when you are looking at the front of the crank. * After installing the LPOP gears, pack them with Vaseline or assembly lube. This will create suction and start pumping oil throughout the engine immediately. * When the assembly is finished, fill the oil through the oil filter housing so it starts filling all of the cavities in the engine instead of just going straight to the oil pan. * Use the injector clamps that we send with the engine and return the old ones with the core. * Don't over torque your injectors. 28 FtLbs is good. [/QUOTE]

Random media

20150719_151902

20140325_095243

Coolant_filter_kit

step_5

clutch4

phone_pics_056

IMG_20130603_143152_263

Latest posts

Won’t start issues
- Latest: psduser1
- Monday at 8:30 PM
7.3 Tech & FAQ
Windshield washer fluid reservoir
- Latest: psduser1
- Monday at 8:27 PM
7.3 Tech & FAQ
F-250 & F-350 gear ratio question ?
- Latest: Mark Kovalsky
- Sunday at 6:57 PM
6.7 Tech & FAQ
Y
2001 Ford F350 7.3 l powerstroke diesel windshield washer fluid reservoir
- Latest: Yojih123
- Sunday at 12:15 PM
7.3 Tech & FAQ
s364.5
- Latest: htsummers22
- Sunday at 10:54 PM
Want to Buy

Members online

No members online now.

Total: 718 (members: 0, guests: 718)

Top