Reply to thread

Message: [QUOTE="oneturboforme, post: 207395, member: 2627"] Here's what I did short and simple.... Hpfp is 12mmx1.5mm pitch...you can oreder fittings from summit that convert that into a an fitting... I ran from my airdog 10an stainless braided to my hpfp.. as for a return take the return line from the hpfp and cut it on the downstream side of the tee and drill and tap it for a 1/8" npt... Again from summit you can order a 1/8 to whatever an... I used 8an and ran it to where my stock low pressure pump was and installed a 12" aluminum single pass cooler... From there you can use a 3/8 tube fitting, cut the factory steel return line and use that fitting.... I used probably overkill on everything but thats what i chose to do also I use to have a regulator on my fuel system so that the return would actually have to overcome 10psi before it would return... The reasoning behind this is the factory one has to overcome the factory 3psi reg in the factory bowl.... I think it actually helpped with keeping pressure on my hpfp bit i hqvent got a chance to put the regulator back on there yet....hope that helped [/QUOTE]

Verification

Random media

White Out

CNG Setup

2010_interior

my truck!

web_banner_468

Next project

IMAG0714

5A766E13-0921-447D-BF37-F7B873D5B2BE

phone_pics_11-24-12_001

IMAG0331

step_3

Latest posts

GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Yesterday at 1:24 PM
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Thursday at 8:52 PM
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Thursday at 6:23 AM
6.0 Tech
T
2013+ steering gearbox in older trucks
- Latest: TPOLO
- Wednesday at 11:09 AM
Suspension, Drive Train, and Tires
J
15 cab on 08
- Latest: jeretl
- Monday at 2:38 AM
Aftermarket Super Duty 1999 - Current

Members online

No members online now.

Total: 350 (members: 0, guests: 350)

Top