Reply to thread

Message: [QUOTE="TRUBBS, post: 1527795, member: 26"] I actually found my issue as a last ditch hailmarry after everything in fords pinpoint diagnosis turned up nothing, and no one I talked to could think of anything else to look at. and could be your guys issue as well, Ford had an updated calibration/configuration at some point during the run on the 6.4, this truck I was working on never had been back to the dealer for work so it never got the update. I had them update this truck to the latest & greatest files (had an update for the PCM & TCM) and bam problem was fixed. I tried everything before, Swapped HP pumps again to make sure I didn’t get a bad one, swapped LP, Rail sensor, Downloaded a new H&S PCM recovery file my buddy has from back when they were open ext.. and nothing worked to fix it, till I had the pcm updated & BAM problem was gone! I know how frustrating this can be as I fought it for weeks and lost my @$$ on doing it, I searched everywhere & talked to anyone who I felt could offer valuable advice and never could find a fix. So hopefully this helps someone else who’s struggling to find a fix. [/QUOTE]

Verification

Random media

rear_axle_12_

My rig

20171227_153050

20140325_095156

TheSmokinStroke2002

1291077660147

20151111_135059

6.7_VectorManifolds

truck27

Dual IPRs

DSCF1102

Latest posts

2010 headunit
- Latest: glog
- Today at 1:17 PM
6.4 Tech
10R140 failure
- Latest: Sterling6.7
- Yesterday at 8:54 PM
2017+ 6.7 Aluminum Super Duty
D
Turning off the Auxiliary powertrain control module
- Latest: donaldtfreeman
- Yesterday at 10:43 AM
6.0 Tech & FAQ
4r100 P0715/P0717 trouble codes.
- Latest: Tiha
- Yesterday at 8:07 AM
7.3 Tech & FAQ
I must be getting old… Exhaust is too loud
- Latest: ju015dd
- Sunday at 7:59 AM
6.0 Aftermarket

Members online

No members online now.

Total: 331 (members: 0, guests: 331)

Top