Reply to thread

Message: [QUOTE="LiftedBlackHD, post: 1474433, member: 5639"] I went from 38 15.5 20 Toyo MT's to 36 15.5 16 mickey thompson Baja mtz's. First couple times I drove the truck it was fine. I then drove it a few weeks later and it hops up and down while driving. I can feel it at all speeds but particularly at about 40mph. I dont think this is the death wobble. The wheel is not shaking side to side. The old tires wore down more on the inside. So far all I have done to remedy the situation is change upper and lower ball joints and alignment. I inspected everything to ensure everything is tight. The only thing I can find loose is the drivers side rear sway bar end link. I tried to tighten it but it won't turn. It almost feels like the tires have a flat spot. The wheels and tires came mounted and balanced from National tire and wheel. My next plan was to get the tires rebalanced. Would going from 38's to 36's change the driveline angle? Should I take out a couple shims? Any other ideas? Thanks [/QUOTE]

Verification

Random media

CNG Setup

2011-08-10_19-17-11_22

new all-terains

step_4

step_13-1

OBS_96_stroke

2009 F250

Kazakhstan

Latest posts

2010 headunit
- Latest: glog
- Today at 1:17 PM
6.4 Tech
10R140 failure
- Latest: Sterling6.7
- Yesterday at 8:54 PM
2017+ 6.7 Aluminum Super Duty
D
Turning off the Auxiliary powertrain control module
- Latest: donaldtfreeman
- Yesterday at 10:43 AM
6.0 Tech & FAQ
4r100 P0715/P0717 trouble codes.
- Latest: Tiha
- Yesterday at 8:07 AM
7.3 Tech & FAQ
I must be getting old… Exhaust is too loud
- Latest: ju015dd
- Sunday at 7:59 AM
6.0 Aftermarket

Members online

No members online now.

Total: 282 (members: 0, guests: 282)

Top