Reply to thread

Message: [QUOTE="Derek@Vision Diesel, post: 434120, member: 344"] I measured 3 rods and they were all identical. Valves had to of been the compression issue. The BO gasket along with the heads being machined incorrectly accounted for the piston/valve contact. And that is most likely the noise it was making also. This might be a dumb question, and I have my own theory. If the deck of the block is 100% flat from front to back but it was setup up like 1* off in the decking machine, you basically just loose a little compression as you go back. There aren't any other consequences of the block being flat but not level is there? The block is straight, it was just set in the machine wrong when they decked it. [/QUOTE]

Verification

Random media

08_xl_front_left

torque_an_me_10-11_020

2012-05-05_11-41-58_863

buddies

Turkey_Run_035

no_limit_free_shirt

B062F4B2-E082-416E-BFF3-DCC25D771AFC

HX40 map

2012-03-04_16-26-35_766

20170502_2124271

Latest posts

2000 f350 dually lariat
- Latest: ju015dd
- Today at 10:21 AM
7.3 Aftermarket
100k, runs like crap
- Latest: DEEZUZ
- Friday at 8:55 PM
6.7 Tech
A better 7.3 cam sensor!
- Latest: ju015dd
- Friday at 12:38 PM
7.3 Tech
Blue-ish white smoke when at operating temp
- Latest: DEEZUZ
- Monday at 8:53 PM
7.3 Tech
Hard steer question/issue
- Latest: psduser1
- Monday at 8:18 PM
7.3 Tech

Members online

No members online now.

Total: 301 (members: 0, guests: 301)

Top