Reply to thread

Message: [QUOTE="444getsitdone, post: 536876, member: 1882"] I took the driver’s side valve cover to check out the rockers and I only took out #2 intake and #8 intake both were in good shape and I put them both back in and then turn it over without it starting and it made this thumping noise coming from #8 cylinder like if you bang a balloon against your hand. So today I took off the valve cover again and the #8 intake push rod was bent, I straitened it out the best I could so it would hopefully work till I could get a new one, so I put it back in and unlike last time I put cylinder 8 at TDC after I put it in I hand cranked the engine about 2-3 times around just to make everything was ok so I took off the rocker and the push rod was bent again it’s like the lifter won’t go down enough and then I guess the piston it pushing against the valve bending the push rod, I don’t think the valve is bent. I just don’t get what’s happening #2 rocker and push rod are fine. Thanks you guys. [/QUOTE]

Verification

Random media

f250_rendering

00606_lu0hkrw9v1L_600x450

IMG_20150328_153726746_HDR

phone_2017_472

169815_1660981239184_1076760051_1781960_6725912_o

IMG_20110628_153635

Infinity bundle

Pea_shooter

Latest posts

2000 f350 dually lariat
- Latest: ju015dd
- Yesterday at 9:10 PM
7.3 Aftermarket
new build input welcomed
- Latest: btoler4th
- Yesterday at 3:37 PM
6.4 Aftermarket
OEM LED sport headlights
- Latest: ghohouston
- Yesterday at 8:37 AM
2017+ 6.7 Aluminum Super Duty
Gauge cluster face plates
- Latest: crash86
- Sunday at 5:15 PM
6.0 Aftermarket
B
6.4 head gasket job cost
- Latest: bowhunter
- Sunday at 2:07 PM
6.4 Aftermarket

Members online

GudrunSuth

Total: 445 (members: 1, guests: 444)

Top