Reply to thread

Message: [QUOTE="cowboy_dan, post: 63334, member: 258"] A knurling tool on the lathe. [url]http://www.wttool.com/common/images/product/main/22130010.jpg[/url] Basically two wheels with grooves in them. One wheel has the grooves sloping up & right, the other has the grooves sloping up & left. Since they contact roughly the same area of the part, they make a criss-cross pattern that is the knurling. It doesn't cut anything, it just pushes the metal around. It takes quite a bit of force to get a good knurl (might also be that the tool I used was dull), so it's pretty hard to knurl small parts unless you get one of the more expensive knurlers that grabs on both sides of the part: [url]http://www.wttool.com/common/images/product/medium/22130025.jpg[/url] [/QUOTE]

Verification

Random media

IMG_20130328_194115_589

Picture_019

572

2011_pics_138

Step_101

Picture_057

IMAG0070

Weight Reduction,one part at a time

SHAQ

E43548C7-F3FB-464A-B461-7A5BC5F506C1

Latest posts

10R140 failure
- Latest: PSD-BLACK-CLOUD
- Friday at 1:04 PM
2017+ 6.7 Aluminum Super Duty
2010 headunit
- Latest: glog
- Wednesday at 1:17 PM
6.4 Tech
D
Turning off the Auxiliary powertrain control module
- Latest: donaldtfreeman
- Tuesday at 10:43 AM
6.0 Tech & FAQ
4r100 P0715/P0717 trouble codes.
- Latest: Tiha
- Tuesday at 8:07 AM
7.3 Tech & FAQ
I must be getting old… Exhaust is too loud
- Latest: ju015dd
- May 4, 2025
6.0 Aftermarket

Members online

Total: 953 (members: 2, guests: 951)

Top