Reply to thread

Message: [QUOTE="Dzchey21, post: 531416, member: 63"] That's some of the basics that I really need to address and make a thread about. Basically you can change that from offset to multiply, divide, copy/compare Ect. What that does is you can highlight the box, boxes, or whole table This is handy when say you would like to raise the back pressure table 10% You simply highlight the whole table,.set the function to multiply, and then in the value input "1.10" this would multiply every table by 10 percent. This is a great way to.modify a tune to see changes or make changes slightly as you go. I basically did this with both low boost fueling and back pressure to help the truck spool faster and smoke less. [/QUOTE]

Verification

Random media

Bronco tear down

20170502_2124171

IMG_20111001_135247

IMAG0070

pistons

old_bed_off

stolen2

2006 F350 KR Utility bed

2006 Lariat Custom truck McIntosh Sound System, Pipe Fitters Truck.

F150 and F250

Latest posts

Won’t start
- Latest: psduser1
- Yesterday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Friday at 1:24 PM
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Jun 5, 2025
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Jun 5, 2025
6.0 Tech
T
2013+ steering gearbox in older trucks
- Latest: TPOLO
- Jun 4, 2025
Suspension, Drive Train, and Tires

Members online

No members online now.

Total: 258 (members: 0, guests: 258)

Top