Reply to thread

Message: [QUOTE="farmin powerstroke, post: 888931, member: 5795"] As the title states the truck is a 2008 f250 ccsb it was featured in the June issue of diesel power. the truck was my daily driver until a couple mouths ago. In the middle of harvest it started a miss and had low compression in two cylinders. [ATTACH=full]125444[/ATTACH] The truck just had an intake tuner a delete on it for almost a year. Then The first part of my build was the reliability stuff Studs Spring 4 in down pipe Flo pro elbow Lp batmo wheel Air dog Innovative tunes Nothing to crazy, then the fall before this it developed a high pressure fuel leak and wouldn't start. After finding that it was a lose fitting I didn't get tight. we added 30% nozzles, a dragon fire, and a hp batmowheel. It ran great for about three days then the trans had enough. Then built the trans and had fun with it. Started adding some more over the winter and spring including no limit intake and inter cooler, dual shocks, traction bars. When summer came around I pulled it a couple times. After that I decided to a tow powers and ended up going with rcd 75/59. Then it got expensive fast I hooked it that night and bloke the low reverse hub and ruined almost everything from the converter and input shaft to the output shaft. Not a good day to say the least. [ATTACH=full]125445[/ATTACH] Finally got it back together with a new rcd convertor and input shaft and Morgan built the trans again and added billet internals. At that point it ran for a while, I dynoed a scheid and layed down 811.1 hp. It ran into fall and hooked one more time. It ran for about three weeks. Then one day it started a miss and had a lot of blow by so I parked it until about a week ago. Now the plans are as follows R&R rods Midwest forged pistons Ati damper Balanced rotating assembly Stage three Midwest ported intake manifold Midwest cam New lifters 6.0 manifolds and up pipes Waste gate Single rear wheel Dana 80 4:10 gear swap Tru trac for the Dana 80 Full head porting Fuel bowl delete Convertor lock trans tunes I'm going to build a hitch as the factory ford hitch is bent after just a few hooks and will be adding a roll pan, stack and possibly a weight bracket in the bed for suit case weights. I'm going to try and get it as light as possible so I can have movable weight. Sent from my iPad using Tapatalk [/QUOTE]