Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
New showcase items
New showcase comments
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Showcase
New items
New comments
Latest content
Latest reviews
Latest updates
Search showcase
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Power Strokes
6.0 Tech
Miss and tick after head job
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="Luke@MillerPerformance, post: 1472382, member: 12303"] Jump the start wire with key off and see if the engine sounds even spinning over. Redneck cylinder balance test. If it's even pull the #4 injector and check the copper washer to make sure it is seated. I've had countless sets of heads with junk stuck in the bolt hole for the injector that stops it from tightening down all the way. If that's good, with the injector out roll the motor around until is on TDC compression for cylinder 4 (valves closed, piston at TDC, easy to verify with injector out and small screw driver in injector hole to watch piston movement). Then use a rubber tip on a blow gun and pressurize the cylinder and listen for air out of the valves. No air, means the engine is mechanically fine and you probably have a bad injector/injector wiring. These engines have some tough valves, every time I've seen someone miss the lifter it bends and push rod and the valves are fine. [/QUOTE]
Insert quotes…
Verification
Post reply
Random media
Latest posts
6.0 No Idle, Runs all day when held above 900 rpm
Latest: DEEZUZ
Yesterday at 9:38 AM
6.0 Tech
Heui Injection
Latest: Charles
Yesterday at 12:05 AM
7.3 Aftermarket
S
CAT oil filter upgrade
Latest: sirkdev
Thursday at 12:32 AM
2017+ 6.7 Aluminum Super Duty
Tuning 101 - Thread Merged with Injector Posts
Latest: Tiha
Wednesday at 12:50 PM
7.3 Aftermarket
20% TO 40% OFF ON FORD OEM PARTS
Latest: Powerstroke Cowboy
Tuesday at 3:48 PM
Sunrise Ford Parts
Members online
No members online now.
Forums
Power Strokes
6.0 Tech
Miss and tick after head job
Top