Reply to thread

Message: [QUOTE="bigrpowr, post: 651200, member: 806"] As we all know, every truck is different. occasionally i get kits that come back as " no fit" , this problem can be a multitude of things. My kit was based on a truck that had its cab centered, and the factory cold side parts fit perfectly on. that being said not every truck is the same, some not even close, sometimes the cab isnt centered, the truck has been in a fender bender, etc.. remember we are bolting almost 5 feet of 3" pipe that goes front to back and side to side, from a fixed location to a not fixed location. i have found the best solution i could think of to remedy 99% of the issues seen. i took and did a slotted on center flange to allow for almost a full inch at the silicon connection end to help with fitment of off the wall trucks. here's a peek, these will begin to be standard issue in the next few weeks as old stock is gone thru. only a few will even need this, but i hope it helps. [ATTACH=full]108162[/ATTACH] [/QUOTE]

Verification

Random media

eleanor_at_dereks_3_

3792

phone_2017_224

safe_008

2011-11-23_13-33-20_233

phone_2017_226

Big_Red15

Built_Up_Motor_2

Latest posts

S
F-350 Dually tire size
- Latest: Smokin 6.0
- Today at 1:51 PM
6.7 Tech & FAQ
S
F-250 & F-350 gear ratio question ?
- Latest: Smokin 6.0
- Today at 1:51 PM
6.7 Tech & FAQ
D
‘10 6.4 rebuild
- Latest: Dieselnewb64
- May 22, 2025
6.4 Tech & FAQ
Won’t start issues
- Latest: psduser1
- May 18, 2025
7.3 Tech & FAQ
Windshield washer fluid reservoir
- Latest: psduser1
- May 18, 2025
7.3 Tech & FAQ

Members online

No members online now.

Total: 791 (members: 0, guests: 791)

Top