Reply to thread

Message: [QUOTE="riverboy460, post: 903945, member: 12627"] For anyone wondering if the check ball was left out no it wasn't. I put it in then put the edge filter in. and I verified after I screwed the new non serviceable plug in that it was still centered in place. so I tightened it down to spec. the little check ball was a tan color. I really think its a ipr issue personally. also is there any difference in the hpop line disconnect fitting springs. I might have mixed up the 2 springs on the bench but I put them both back in with the metal shim facing down ward on both fittings. also in case I didn't mention 2 the hpop resovoir was full and its pumping oil. I know because I cheked the level and forgot to put the plug on stupid me and shot about 2 quarts on the floor. and yes I topped the engine back off just not sure y it wont fire. [/QUOTE]

Verification

Random media

tow_truck_3

30BD9176-5327-47FD-8515-154B45104215

2008 FX4

421539_3278677734606_1497394897_33112692_961297851_n

tornado1

171

rear set-up

IMAG0523

6.4

2012-03-06_13-06-39_891

VVASSUP Juanito's F250 05 6.0 Harley Davidson TOYO RIZE RBP SCT MBRP S&

Latest posts

Gauge cluster face plates
- Latest: crash86
- Today at 5:15 PM
6.0 Aftermarket
B
6.4 head gasket job cost
- Latest: bowhunter
- Today at 2:07 PM
6.4 Aftermarket
S
6R140 surging issue
- Latest: Smokin 6.0
- Today at 12:11 AM
6.7 Tech & FAQ
Won’t start
- Latest: psduser1
- Wednesday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Jun 6, 2025
Engine and Drivetrain

Members online

Total: 255 (members: 2, guests: 253)

Top