Reply to thread

Message: [QUOTE="mstng5point0, post: 1099979, member: 16906"] So a little info its an 07 i just did head gaskets, studs, oil cooler, egr delete, stc fitting, updated stand pipes and dummy plugs all new gaskets from the heads up and new inj o rings. Filled up with rotella t6. Has a ficm by ficm repair. Truck ran great before doing the work. It started right up after but is skipping on #7 suspect bent push rod. They are coming tomorrow so i will pull it apart for that. It has always started even with the skip. Went to start to pull inside the shop at night and i started around a few seconds of cranking and died. I tried to restart it kicked a few times but now start. Now it doesnt even fire. Pulled the ipr to check screen as icp was only 150 psi. Screen had a little crap on it but not much. Put it back in and went to start again and nothing. 150 psi after cranking for a few seconds. Noticed the oil pressure on the dash didnt seem to come up. I will try again tomorrow. Truck ran great before doing the work. Now it wont even run. [/QUOTE]

Verification

Random media

Truck

photo_1_3

2013-02-28_14-55-39_771

Resampled952011-11-059517-05-5395567

IMAG1297

IMG_20140506_222559_903

The Truck

Stock TDE1 Timing

Resized_20180325_191839_6530

Big_Red16

Latest posts

Truck slipping into 4th
- Latest: Sterling6.7
- Friday at 7:18 PM
6.7 Tech
Do not recommend Choate Engineering
- Latest: DEEZUZ
- Wednesday at 10:22 PM
Newly Enlisted
A few turbo questions and a rant
- Latest: ghohouston
- Wednesday at 9:41 PM
7.3 Aftermarket
O
2011-2016 Radiator upgrade
- Latest: OtisCreekConstruction
- Wednesday at 6:17 PM
6.7 Tech
Performance shops
- Latest: DEEZUZ
- Apr 22, 2025
7.3 Performance

Members online

TRUBBS

Total: 793 (members: 1, guests: 792)

Top