Reply to thread

Message: [QUOTE="Strokersace, post: 1461892, member: 622"] Depends on how far you want to go with it. On my obs, I ran 5200 lb front coils, and could barely fit 33x12.5s. This was with a 9" wide -12 offset rim. The tread was very close to the rear corner of the fender when turning on flat ground and if there was any suspension flex, it would make contact. With a factory 2" rear block, b code SD springs, and velvet ride shackles my rear end was approx 1 1/2" higher than the front. However it looked more level than a "leveled" pickup that often looks nose high (to me). What size is the factory rear block in the doner? And front spring rate? With your body lift, you'll have extra room. If you want to keep it, 35's may just work with a stock spring and maybe a small bottom coil spacer. If so, no drop brackets will be needed. If removing the body lift, you'll definitely need 2.5" leveling coils (or spacers), adjustable track bar, and either a 3-link setup or arm drop brackets. Sent from my SCH-I545 using Tapatalk [/QUOTE]

Verification

Random media

photo_3_1

20151116_172104

285421_10151217541911265_2098362536_n

The Gooseneck trailer

New Procomp tires

BIG_DIRTY_

Expansion_SMK200

Stock_Fuel

Latest posts

02 F250 7.3 Will crank, WTS stays on, no start, no OBD
- Latest: Sterling6.7
- Sunday at 8:57 PM
7.3 Tech
P0087
- Latest: DEEZUZ
- Sunday at 11:49 AM
6.4 Tech & FAQ
2015-2019 6.7 HPFP New In Box
- Latest: lincolnlocker
- Jun 1, 2026
Engine and Drivetrain
First 6.0L (56k warning)
- Latest: adrianspeeder
- May 26, 2026
6.0 Tech
Extra external motor oil cooler?
- Latest: justinlogue5_0
- May 26, 2026
7.3 Tech

Members online

jesspitb

Total: 669 (members: 1, guests: 668)

Top