Reply to thread

Message: [QUOTE="907DAVE, post: 187047, member: 672"] ICP is never that stable, and is always fluctuating a bit - which could just be caused by a slow sample rate with the Scangauge. But ICP should read zero or close to it after the motor has been shut down - not +3500 PSI. It should also raise and lower with RPM's, which I do not believe it did. Also, IPR% should increase to increase pressure. In that video it was only 3% or 5% when the ICP was sky high.....something is not reading right. Did you wire your IPR's in series? [/QUOTE]

Verification

Random media

part

step_5

20170502_212705

6.4 Fluidampr vs stock

silver_truck_under_hood_dual_pumps

P6190001

Blower_Diagram

20160924_133950

IMAG0153

Rear

Latest posts

Gauge cluster face plates
- Latest: crash86
- Yesterday at 5:15 PM
6.0 Aftermarket
B
6.4 head gasket job cost
- Latest: bowhunter
- Yesterday at 2:07 PM
6.4 Aftermarket
S
6R140 surging issue
- Latest: Smokin 6.0
- Yesterday at 12:11 AM
6.7 Tech & FAQ
Won’t start
- Latest: psduser1
- Wednesday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Jun 6, 2025
Engine and Drivetrain

Members online

No members online now.

Total: 240 (members: 0, guests: 240)

Top