Reply to thread

Message: [QUOTE="Powerstroke Cowboy, post: 919556, member: 610"] Not sure to be honest with. I would not do it. But if you do not mind having a welded hose go for it! It should work though. On a side note welding it would be neat and clean. It might be a aluminized steel. I think the factory line is steel. What I did for the return. I just went and looked at to do be sure. I took and spliced the factory rubber return hose to the AirDog return hose. All you need is a reducer barb fitting. Or you can make your own out of pipe fitting and threaded barbed ends. Quick simple and easy. I mounted the AirDog about 12 inches away from the fuel selector valve. Where are you putting yours? [/QUOTE]

Verification

Random media

20170502_2125011

Misc_V-Drive_557

joestruck1

ece6bbcf

High Pressure Oil Leak Problem

20170502_2125491

IMG_20140824_203833_842

1263_4492888300698_1484592670_n-2

3.5inch sd vs 3inch ranger

IMAG0030

2011-07-23_13-19-32_1

Picture_058

Latest posts

10R140 failure
- Latest: PSD-BLACK-CLOUD
- Friday at 1:04 PM
2017+ 6.7 Aluminum Super Duty
2010 headunit
- Latest: glog
- Wednesday at 1:17 PM
6.4 Tech
D
Turning off the Auxiliary powertrain control module
- Latest: donaldtfreeman
- May 6, 2025
6.0 Tech & FAQ
4r100 P0715/P0717 trouble codes.
- Latest: Tiha
- May 6, 2025
7.3 Tech & FAQ
I must be getting old… Exhaust is too loud
- Latest: ju015dd
- May 4, 2025
6.0 Aftermarket

Members online

6.0 Tech

Total: 476 (members: 1, guests: 475)

Top