Reply to thread

Message: [QUOTE="psduser1, post: 1073186, member: 735"] Alright, I know there's no love for this hpop, but my Srp 1.1 is treating me pretty well, so far. My question pertains to the oil ports and lines to the heads. Per gary, the ports are a #8 stc fitting, as opposed to the stock #6. Would there be any benefit to running a bigger line to each head, and tying into two points on each head. A fairly accurate rule of thumb with piping is "one size bigger, quadruple the flow at any given pressure", so theoretically, a 1/2 line tee'd into two 3/8" lines, per head, " should" increase available oil volume at each head. An earlier thread, magnumpd's, if I remember, covered swapping a dual pump setup over to jic, with four lines. This is along the same lines, just with a bigger single pump. Wondered if anyone has tried this, and if there was any benefit, or not worth the time? I'm going to a jic setup anyway, as my stock lines are starting to weep oil at the crimp fittings, and with 3 trucks to cover, ford is too proud of their parts, lol.:gun: [/QUOTE]

Verification

Random media

1511MG-3041

s-l500

photo_7_3

frt

POWER-STRUCK parts

Spray adhesive that sticks to the rubber and plastic

2008 Ford F-250

cup

1263_4492888300698_1484592670_n-2

2008 Ford F-250

Nason white paint

Latest posts

02 F250 7.3 Will crank, WTS stays on, no start, no OBD
- Latest: Sterling6.7
- Yesterday at 9:04 PM
7.3 Tech
2015-2019 6.7 HPFP New In Box
- Latest: lincolnlocker
- Monday at 1:26 PM
Engine and Drivetrain
First 6.0L (56k warning)
- Latest: adrianspeeder
- May 26, 2026
6.0 Tech
Extra external motor oil cooler?
- Latest: justinlogue5_0
- May 26, 2026
7.3 Tech
Weird Electrical Issue
- Latest: justinlogue5_0
- May 26, 2026
7.3 Tech

Members online

No members online now.

Total: 8,626 (members: 0, guests: 8,626)

Top