Reply to thread

Message: [QUOTE="slow poke, post: 826959, member: 9453"] I know what the codes mean, P0673 Cylinder 3 Glow Plug Circuit/Open and P0703 Brake Switch B Input Circuit, but what might be causing it? Also, what is considered blow by? I took the oil cap off and let it idle for a bit but I'm not sure what to look for. There was some steam coming out of it but it was only 35 degrees out when I just did it tonight. I put my hand over the opening while it was running and there was no oil, or even a oil smell really, on my hand after. I cleared the codes with my H&S but after a few starts, the check engine light is back on again. Where should I start looking you think to figure out how to fix this? Thanks guys for any help you could pass along...... [/QUOTE]

Random media

2011-09-01_17-42-03_0

mpd_kit_1

no so clean anymore

pb_mobileweb_logo120

BB3C04D5-BB5B-4F75-9207-BBD824089A43_11

SAM_0889

2012-08-19_17-15-44_956

diamond eye exhaust 5

IMAG0901

Truck

phone_2017_224

Latest posts

2010 headunit
- Latest: glog
- 20 minutes ago
6.4 Tech
10R140 failure
- Latest: Sterling6.7
- Yesterday at 8:54 PM
2017+ 6.7 Aluminum Super Duty
D
Turning off the Auxiliary powertrain control module
- Latest: donaldtfreeman
- Yesterday at 10:43 AM
6.0 Tech & FAQ
4r100 P0715/P0717 trouble codes.
- Latest: Tiha
- Yesterday at 8:07 AM
7.3 Tech & FAQ
I must be getting old… Exhaust is too loud
- Latest: ju015dd
- Sunday at 7:59 AM
6.0 Aftermarket

Members online

No members online now.

Total: 306 (members: 0, guests: 306)

Top