Reply to thread

Message: [QUOTE="JD3020, post: 1150740, member: 373"] Hoping to get my Optishift trans controller installed on the truck soon, but i'd like some advice from the guys that have done it. I know most guys here run a PCS, but this should be pretty much identical. Mainly looking for the best place and method to tap into the factory wires. I want to do it cleanly in case i remove the controller down the road. I'm also wanting to use my cruise control buttons for the manual shift like a couple guys here have done. I'm sure this is pretty simple, but i HATE wiring and i hate modding a factory harness. From what i've gathered on their this is a list of wires i need to tap into: Keyed 12v power PCM ground TPS input to the PCM VSS+ wire between PSOM and PCM. 2 wires at the PRDNL switch for range selection Blue/Black wire in the steering column for cruise control [/QUOTE]

Verification

Random media

SSBC Brakes

2008 6.4L pic11

564990_3644203551334_506888378_n

2011-07-30_13-13-34_958

2008 FX4

Difference in camel tan to pebble tan

my old 6.0 after mom drove it

befor an after

558206_4175518193868_289576718_n

20140221_181947

024

Latest posts

S
6R140 surging issue
- Latest: Smokin 6.0
- Today at 12:11 AM
6.7 Tech & FAQ
Won’t start
- Latest: psduser1
- Wednesday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Jun 6, 2025
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Jun 5, 2025
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Jun 5, 2025
6.0 Tech

Members online

No members online now.

Total: 217 (members: 0, guests: 217)

Top