Reply to thread

Message: [QUOTE="CanadianStroker, post: 1490958, member: 13285"] The next day I got the truck turned around, also using the skid steer. Still have work on the rear to do. Change yoke on rear axle, Question: I have my super duty driveshafts still, but my super duty shaft is too short to bolt up. But theres guys using the SD drive shafts? Could someone help me out with this? Install driveshaft Install new flex line from frame to axle(not sure of length at the moment) Install new pads and rotors Most likely need a lift block, but unsure at the moment E-brake cables and shoes(but might just do that in the spring) Change differential fluid I think thats it... Onto the pictures, Front of truck now starting disassembly. [URL="https://imgur.com/WXnefxt"]https://imgur.com/WXnefxt[/URL] [URL="https://imgur.com/9diRkOK"]https://imgur.com/9diRkOK[/URL] [URL="https://imgur.com/02NEZIK"]https://imgur.com/02NEZIK[/URL] Look at all this good northern rot, and previous owner claimed rust free... [URL="https://imgur.com/2ZrVkNp"]https://imgur.com/2ZrVkNp[/URL] [URL="https://imgur.com/pwBD9WG"]https://imgur.com/pwBD9WG[/URL] [URL="https://imgur.com/dKsF3yl"]https://imgur.com/dKsF3yl[/URL] [URL="https://imgur.com/U4sBKpd"]https://imgur.com/U4sBKpd[/URL] Truck does have the Banks Technicooler system, And the holes that the shop cut into the rad support were probably not some of his best work... [URL="https://imgur.com/aL6kmmG"]https://imgur.com/aL6kmmG[/URL] [URL="https://imgur.com/N4GyOlx"]https://imgur.com/N4GyOlx[/URL] [URL="https://imgur.com/p4dqpTf"]https://imgur.com/p4dqpTf[/URL] Would these be production numbers? [URL="https://imgur.com/my4y74u"]https://imgur.com/my4y74u[/URL] [URL="https://imgur.com/9diRkOK"]https://imgur.com/9diRkOK[/URL] [URL="https://imgur.com/02NEZIK"]https://imgur.com/02NEZIK[/URL] [/QUOTE]