Reply to thread

Message: [QUOTE="superpsd, post: 1425005, member: 15821"] It Sounds like you are paying a shop that has not a clue what they are truly doing. They want you to pay top dollar for a rebuild that is likely way out of spec and try and compensate by shorter push rods that will limit valve lift. One last time and not that my advice matters. I would pull the plug. Tell them to had over the rebuilt shortblock and find a good used tested guaranteed engine from a yard etc and get the truck on the road. Then store the short block and finish it as funds allow and or sell it and cut your losses. If they ****ed up valve to piston clearance this far along the main question is what else did they do half assed and do you want to spend the time putting the engine back in the truck to find out you got hosed. [/QUOTE]

Verification

Random media

original_eleanor_1_

IMG_20140824_203833_842

Picture_1207

2011-11-09_18-15-18_93

2011-04-20_14-50-31_741

2013-03-21_16-46-23_34

sept_29_10_1691

2014 6.7

F-4E_Refueling

IMAG0382

Latest posts

02 F250 7.3 Will crank, WTS stays on, no start, no OBD
- Latest: Sterling6.7
- Sunday at 8:57 PM
7.3 Tech
P0087
- Latest: DEEZUZ
- Sunday at 11:49 AM
6.4 Tech & FAQ
2015-2019 6.7 HPFP New In Box
- Latest: lincolnlocker
- Jun 1, 2026
Engine and Drivetrain
First 6.0L (56k warning)
- Latest: adrianspeeder
- May 26, 2026
6.0 Tech
Extra external motor oil cooler?
- Latest: justinlogue5_0
- May 26, 2026
7.3 Tech

Members online

No members online now.

Total: 7,599 (members: 0, guests: 7,599)

Top