Reply to thread

Message: [QUOTE="Sooter6.7, post: 1247090, member: 21965"] So guys I am deleted with mikes EGR kit and I have never been able to read my EGTS. I have purchased a H&s pyro kit since I have a MM but was told from experienced posters on the H&s forum to just go with gauges it will make everything easier.. Well I took my intake off and was going to try to put a season from the stock exhaust in my block off planet but then noticed the sensor was not plugged in. I plugged it in (to I think the throttle body) and I'm getting readings in the 1500s from a start up and letting her sit now reading mid 1300 but jumping around. Queston is are these normal temps? Should I just say F*** it and install my EGT gauge? If this is the right temp and it's working properly can I have 2 probes and read my egs on my mm from pyro and season in manifold? Thanks for any advice hoping to get this done in a couple hours [/QUOTE]

Verification

Random media

IMAG0326

101431-I-like-it-a-lot-gif-Dumb-and-D-XKuE

crowfoot_wrench_1

photo_26

246835_166853036711691_100001609875209_422855_2678983_n

20171227_152841

2017LEVEL

eleanor_part_two_37_

2012-07-22_16-58-12_561

Iron Bully Bumpers

Latest posts

GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Friday at 1:24 PM
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Thursday at 8:52 PM
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Thursday at 6:23 AM
6.0 Tech
T
2013+ steering gearbox in older trucks
- Latest: TPOLO
- Wednesday at 11:09 AM
Suspension, Drive Train, and Tires
J
15 cab on 08
- Latest: jeretl
- Monday at 2:38 AM
Aftermarket Super Duty 1999 - Current

Members online

Total: 753 (members: 2, guests: 751)

Top