Reply to thread

Message: [QUOTE="Dirtclod, post: 1455744, member: 20061"] Ok I've been dealing wirh this issue for quite a while now. The rear end was acting as if I had a bent rim. Like a wobble. Changed tires,rims,rotors,pads,new caliper,new tires. All the universals I n the drive shaft have been changed,even in the front drive shat from the transfer case. The carrier bearing twice. All within the past 3 years. Now the rear I joint is bad again and the one before the carrier bearing. I've put it up on jackstands and the passenger side rear tire has an up and down motion,not a side to side. There's no play if grab the wheel try pushing top to bottom or side to side. There is a lot of movement in driveshaft but I wouldn't think it would make one wheel move that way and not the othe other. I removed the wheel and caliper and removed the bolts from the hub to pull the axle. Rear end grease started coming out. Now if it's like the front there shouldn't be any grease coming out there or should it? Also how can you tell if the bearing is bad in the hub or at the axle? [/QUOTE]

Verification

Random media

Arizona on our way to Uma

Sunset

IMG_20140218_185937

Picture_019

step_13-2

photo_2_2

20140613_085156

New_brakes

IMAG0578

575

Latest posts

02 F250 7.3 Will crank, WTS stays on, no start, no OBD
- Latest: Sterling6.7
- Yesterday at 9:04 PM
7.3 Tech
2015-2019 6.7 HPFP New In Box
- Latest: lincolnlocker
- Monday at 1:26 PM
Engine and Drivetrain
First 6.0L (56k warning)
- Latest: adrianspeeder
- May 26, 2026
6.0 Tech
Extra external motor oil cooler?
- Latest: justinlogue5_0
- May 26, 2026
7.3 Tech
Weird Electrical Issue
- Latest: justinlogue5_0
- May 26, 2026
7.3 Tech

Members online

6.0 Tech

Total: 3,104 (members: 1, guests: 3,103)

Top