Reply to thread

Message: [QUOTE="Dieselboy., post: 204339, member: 1232"] Again Im fighting with an oil leak from the back of the motor. Believe the pan is warped from the core engine. I found that leak from when I installed it on the driver side rear corner. However, after pulling the motor, the insepction cover and starter rear main area behind the flexplate is covered in oil. I filled it extra full on the stand with it tilted towards the back to see if I can get it to leak but it only leaks from the pan gasket. I cleaned the back of the motor with break clean. Anyone have any ideas for me to pressurize the motor to simulate it running. I dont think the the oil could work its way agaisnt gravity into the inspection cover and then get throw around. But I dont wanna rip off the rear main seal and cover plate if I dont have to. Thanks. [/QUOTE]

Verification

Random media

IMAG1039

IMG_20130423_192721_897

03 7.3 ZF6

he451ve turbine

eleanor_part_two_33_

like_new_35x13_50r20_mickey_thompson_atz_950_santa_maria_10687625

Minotaur Parameters

12107232_10156110327125035_7893535477827901270_n

08 door sill

983C27CB-9ADA-4E33-B2DF-80CBFF8A98BF

Latest posts

GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Friday at 1:24 PM
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Thursday at 8:52 PM
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Thursday at 6:23 AM
6.0 Tech
T
2013+ steering gearbox in older trucks
- Latest: TPOLO
- Wednesday at 11:09 AM
Suspension, Drive Train, and Tires
J
15 cab on 08
- Latest: jeretl
- Jun 2, 2025
Aftermarket Super Duty 1999 - Current

Members online

No members online now.

Total: 1,039 (members: 0, guests: 1,039)

Top