Reply to thread

Message: [QUOTE="jmsmith76, post: 341543, member: 861"] Anybody got any suggestions on getting the cab to line up? The driver side rear had three 1/8" shims, passenger side had one. I put all those back in and the driver side sat about 11/16" high after torquing down. Pulled all the shims out on the driver side and now it's sitting around 1/2" high. Passenger side is almost perfect, maybe like 1/8" high. Anybody know if the bushings will "settle" after driving for a bit? Or am I looking at shimming the whole body and bed until things line up properly? Also, should probably mention that I have a drum with 45 gallons of used motor oil on the driver side of the bed, and a drum with 30 gallons on the passenger side of the bed. Not sure how much difference that'd make... [/QUOTE]

Verification

Random media

IMG_20181015_215152

Cold_Stack

Link Design

wopgate

maple_grove_014

Capone

eleanor_part_two_15_

front_axle_swap

7.3 XLT CREW CAB 4X4

Capone

tapatalk_1404232564793

HPP_2006_Polaris_900_RMK_159_

Latest posts

GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Friday at 1:24 PM
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Thursday at 8:52 PM
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Thursday at 6:23 AM
6.0 Tech
T
2013+ steering gearbox in older trucks
- Latest: TPOLO
- Wednesday at 11:09 AM
Suspension, Drive Train, and Tires
J
15 cab on 08
- Latest: jeretl
- Jun 2, 2025
Aftermarket Super Duty 1999 - Current

Members online

No members online now.

Total: 1,019 (members: 1, guests: 1,018)

Top