Reply to thread

Message: [QUOTE="JCart, post: 937855, member: 1238"] Just so I'm clear the pin order stays the same, just the SD is all on one plug right? E.g., passenger side outside VC cut front plug off OBS harness connect to 1/2 SD new pigtail then cut rear OBS plug and connect to SD plug keeping all wires in order front to back? My thinking was to connect with butt connectors and dielectric grease inside connector then heat shrink tube over each wire that sound reasonable? Open to suggestions. Also I'll add since using dielectric grease and Stancor GP relay I've not had any pins burn up on my harnesses at all, back in '98 my first psd ('96) with stock GP relay was pretty common to be replacing the relay and burnt pins where all too common. Lastly purchased SD and OBS parts pigtails and UVC harnesses from Clay at Riff Raff great pricing and shipping to Canada. jrc [/QUOTE]

Verification

Random media

2011-04-12_17-33-51_835

Sunset

13_emblem

IMG_20130406_180211_348

DP-Tuner Timing

wopgatekit

Truck21

2011-05-31_17-20-35_79

maple_grove_031

IMAG0329

Latest posts

Won’t start
- Latest: psduser1
- Wednesday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Jun 6, 2025
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Jun 5, 2025
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Jun 5, 2025
6.0 Tech
T
2013+ steering gearbox in older trucks
- Latest: TPOLO
- Jun 4, 2025
Suspension, Drive Train, and Tires

Members online

No members online now.

Total: 261 (members: 0, guests: 261)

Top