Reply to thread

Message: [QUOTE="superpsd, post: 1198200, member: 15821"] Well I've welded a few barrels now. Getting better with every one. All are a go except one is a "not too sure bout that one" I hit it with too much heat and the plunger was very tight until oiling it up and working it down the bore quite a few times. I'll just set that one a side. After pulling injectors out of their shipping boxes I discovered I actually have 14 injectors and one is new. It's tricky welding these with a lift arc machine. I have it down to strike arc, feed the filler fast, one one thousand pull to kill arc and push back in for post flow. Let cool completely on a heat sink and repeat until sealed. I did start ordering parts for E fuel. I purchased Cat 175-2949 water separator for pre pump and the 1R-0750 for post. Still debating over dual SD or A1000? [ATTACH=full]150623[/ATTACH] [/QUOTE]

Verification

Random media

2012-08-19_18-07-59_94

OUO 525

AD2_2_

6_7_CAI_1_

ChrisB_0015_before

2012-05-05_11-41-58_863

112

Picture_644

Latest posts

02 F250 7.3 Will crank, WTS stays on, no start, no OBD
- Latest: Sterling6.7
- Sunday at 8:57 PM
7.3 Tech
P0087
- Latest: DEEZUZ
- Sunday at 11:49 AM
6.4 Tech & FAQ
2015-2019 6.7 HPFP New In Box
- Latest: lincolnlocker
- Jun 1, 2026
Engine and Drivetrain
First 6.0L (56k warning)
- Latest: adrianspeeder
- May 26, 2026
6.0 Tech
Extra external motor oil cooler?
- Latest: justinlogue5_0
- May 26, 2026
7.3 Tech

Members online

projectford

Total: 453 (members: 1, guests: 452)

Top