Reply to thread

Message: [QUOTE="TD-5, post: 821478, member: 12311"] In the discussions on head studs & cracked blocks one of the theorys was the stud might actually bottom in the threaded hole during the torquing proccess, stressing the block & causing it to crack. Wanted to get some depth measurements from a varity of the holes and compare the measurements to the length of threaded section on the stud & see how close they are. Also if all the holes measure the same. Just wondering if inconsistent tollerances in the automated machining process could cause some of the threaded holes to be shallow. NOT likely, but just another thing to eliminate as a cause before I start. I will be measuring the threaded holes in my block just to make sure. [/QUOTE]

Verification

Random media

n1335447039_30451405_445427

2012-01-21_17-36-02_17

IMG_20130423_192721_897

2011-04-12_17-35-52_246

Photo_Dec_14_1_31_59_PM

IMAG0084

2013-03-21_16-58-31_68

09 6.4

Latest posts

9
OEM LED sport headlights
- Latest: 99fordman18
- Today at 8:15 AM
2017+ 6.7 Aluminum Super Duty
10R140 failure
- Latest: PSD-BLACK-CLOUD
- Friday at 1:04 PM
2017+ 6.7 Aluminum Super Duty
2010 headunit
- Latest: glog
- May 7, 2025
6.4 Tech
D
Turning off the Auxiliary powertrain control module
- Latest: donaldtfreeman
- May 6, 2025
6.0 Tech & FAQ
4r100 P0715/P0717 trouble codes.
- Latest: Tiha
- May 6, 2025
7.3 Tech & FAQ

Members online

No members online now.

Total: 1,427 (members: 1, guests: 1,426)

Top