Blowby
Active member
- Joined
- May 22, 2011
- Messages
- 1,532
- Reaction score
- 0
Removed to install a 46mm:
I have a large blue and a small red spring inside to equal 17.5 PSI. If I recall.
All weld on flanges, clamps and bolts/nuts, ready to install.
Link to WG on sale for $399 --- I'll take $299 + shipping.
High temp NiCrFe based alloy is used for valve and 347SS valve housing will offer longer product life compared to competing designs.
- High temperature silicone Nomex reinforced actuator diaphragm.
- 17-7 PH Stainless Steel actuator spring gives consistent pressure at high temperature, resist "relaxing" at temperature to 900F (483C).
- Nitronic 60 Stainless Steel is used for the valve seat, and valve bushing.
- All Stainless Steel hardware.
- Mating weld flanges are 304L
I have a large blue and a small red spring inside to equal 17.5 PSI. If I recall.
All weld on flanges, clamps and bolts/nuts, ready to install.
Link to WG on sale for $399 --- I'll take $299 + shipping.
High temp NiCrFe based alloy is used for valve and 347SS valve housing will offer longer product life compared to competing designs.
- High temperature silicone Nomex reinforced actuator diaphragm.
- 17-7 PH Stainless Steel actuator spring gives consistent pressure at high temperature, resist "relaxing" at temperature to 900F (483C).
- Nitronic 60 Stainless Steel is used for the valve seat, and valve bushing.
- All Stainless Steel hardware.
- Mating weld flanges are 304L
