Reply to thread

Message: [QUOTE="powerstrokedkid87, post: 1278225, member: 1658"] as far as your drain line, I have seen it done in the "bed plate" or upper pan, i ran mind into the side of the oil pan right above were the trans lines sit. I found there was very little room to get a good spot on the top of the upper pan, but a lot of guys do it. as far as the vacuum lines, most would say extend the lines and mount it under the truck somewhere.....i pulled the vacuum canister out of my truck and looped the lines together. I wouldn't recommend it, however i haven't had any issues with it this way. i would think about a little more fuel for the setup, here is a couple pics of my oil pan...there is some good information n that thread also. [url]http://powerstrokearmy.com/forums/showthread.php?t=41925&page=15[/url] [/QUOTE]

Verification

Random media

IMG_20140611_143747_176

truck18

F9F85977-5C8A-4607-8BC2-D92052886746

573

heavybag

Pfm top

imagejpeg_2

2008 King Ranch motor work

2012-08-31_17_31_06

Picture_1206

2012-02-16_14-23-02_341

DI_Party_10-14-06_020

Latest posts

Won’t start
- Latest: psduser1
- Yesterday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Friday at 1:24 PM
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Jun 5, 2025
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Jun 5, 2025
6.0 Tech
T
2013+ steering gearbox in older trucks
- Latest: TPOLO
- Jun 4, 2025
Suspension, Drive Train, and Tires

Members online

projectford

Total: 187 (members: 1, guests: 186)

Top