Reply to thread

Message: [QUOTE="kleake, post: 1505757, member: 25987"] Either this block has been decked before, or the stage 1 cam lobes are a little taller on the low side. I was able to compress the lifter, so that wasn't the issue. I swapped push rods and valve bridges, no change. Ended up putting in one of my previously machined down valve bridges that reduce gives a little more clearance and all is good. Still not understanding which component was different, but all cyl are good. Buttoned it up, went to fire it up and had a major fuel leak on the top of the HPFP. Took a while to dig may way in there and change out the O-rings again, but got it done and solved that issue. Man that's a tight fit down in that hole!!! Anyway, got her fired up, she sounds good, but I haven't taken her for a drive yet. Still gotta put the hood, bumper, and headlights on but I've heat cycled it a couple of times and stalled it up to burn some of the oils off of the manifolds and such. So far, so good. [/QUOTE]

Verification

Random media

bumper_idea_2_

Black Betsy.

bumper, steps, and black painted wheels

IMAG10441

turbo

P6190007

eleanor_part_two_65_

motor

0618111401

20110525185136

Latest posts

2000 f350 dually lariat
- Latest: ju015dd
- Yesterday at 9:10 PM
7.3 Aftermarket
new build input welcomed
- Latest: btoler4th
- Yesterday at 3:37 PM
6.4 Aftermarket
OEM LED sport headlights
- Latest: ghohouston
- Yesterday at 8:37 AM
2017+ 6.7 Aluminum Super Duty
Gauge cluster face plates
- Latest: crash86
- Sunday at 5:15 PM
6.0 Aftermarket
B
6.4 head gasket job cost
- Latest: bowhunter
- Sunday at 2:07 PM
6.4 Aftermarket

Members online

Patrick Feeley

Total: 466 (members: 1, guests: 465)

Top