Reply to thread

Message: [QUOTE="TARM, post: 1420909, member: 578"] Yes the lift can effect things. Usually as lift and tire size goes up some negative wedge camber to push top in and bottom out is needed. Ideally get them wheel aligment shop to first set it to the exact factor rec specs and then vary only from that to correct. MAny shops just got straight to what the computer tells them and it gets things somewhat whacky. I really do not understand why but for whatever reason going to spec first seems to work out best. I think on ford truck there is a long thread on it from a few years ago. Was very helpful to me. If you have one side with bad bearings do both. Its just good practice and without unit bearings not exact costly. But even on my SD when one UB went I did both. Honestly I like having the UB while costly I can change a failed one out in 30 mins. with socket wrench. Ideally I would like to shorten a front axle and use the 550 unit bearings as they are 30%+ bigger. That would be ideal for the larger tires many run. Issue is they are IIRC 3+ " longer than 250-350 UBs [/QUOTE]

Verification

Random media

2012-06-26_16-55-06_419

Amp_Steps

eleanor_part_two_17_

eleanor_wiring_2_

SSBC Brakes

OBS

HD 2006 StreetGlide

getting to the end of build.

DE_4_Pipe

IMG_20150506_204959939

JD 4020

IMG_20110626_1931281

Latest posts

10R140 failure
- Latest: Sterling6.7
- Today at 8:54 PM
2017+ 6.7 Aluminum Super Duty
D
Turning off the Auxiliary powertrain control module
- Latest: donaldtfreeman
- Today at 10:43 AM
6.0 Tech & FAQ
4r100 P0715/P0717 trouble codes.
- Latest: Tiha
- Today at 8:07 AM
7.3 Tech & FAQ
I must be getting old… Exhaust is too loud
- Latest: ju015dd
- Sunday at 7:59 AM
6.0 Aftermarket
2000 f350 dually lariat
- Latest: Powerstroke Cowboy
- Saturday at 8:30 PM
7.3 Aftermarket

Members online

drh4250

Total: 830 (members: 1, guests: 829)

Top