Reply to thread

Message: [QUOTE="JCart, post: 903035, member: 1238"] As a suggestion I only use stock parts for the cooler and especially the cooler to block aluminium gaskets. Tried an IH set once and they didn't fit just right on the front and leaked so I over tightened the front bolts and cracked the front engine cover.... you don't wanna go there. I always make sure I put the same bolts in the same holes they came out of too. If you use a ratchet strap to pull the ends on the cooler upon assembly it works good too, and I also use a small nylon webbing strap to hold it all together when installing (so the ends don't pop off when you are wrestling it in place) then just undo the strap when you have the bolt in and started. cheers, jrc [/QUOTE]

Verification

Random media

one_head

NL64PSCSK

Hydroboost and power steering

front view

Stacks

untitled104

IMAG0454

20160526_164056

td_trucking

IMG_20140611_204353_406

2012-04-10_16-52-03_78

Latest posts

Gauge cluster face plates
- Latest: crash86
- Yesterday at 5:15 PM
6.0 Aftermarket
B
6.4 head gasket job cost
- Latest: bowhunter
- Yesterday at 2:07 PM
6.4 Aftermarket
S
6R140 surging issue
- Latest: Smokin 6.0
- Yesterday at 12:11 AM
6.7 Tech & FAQ
Won’t start
- Latest: psduser1
- Wednesday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Jun 6, 2025
Engine and Drivetrain

Members online

No members online now.

Total: 286 (members: 1, guests: 285)

Top