Reply to thread

Message: [QUOTE="JohnT24, post: 1558628, member: 11219"] I’m getting ready to put the engine back in but I need to assemble up pipes and turbo etc. I do not have an engine stand capable of holding this thing. Do you think it would be OK to gently set it down on the oil pan with some wood blocks (to level it) It’s a brand new oil pan and has been on there at least a week so the silicon should be good and cured. My only other thought is to lift it up in the air and then weld up / fabricate a quick stand to keep it elevated off the floor. My gut feeling is it probably would be OK sitting on the pan. I’ve seen plenty of engines in this position Your thoughts? [ATTACH=full]181038[/ATTACH] [/QUOTE]

Verification

Random media

'07 5.9 Cummins

rear_axle_9_

VVASSUP Juanito's F250 05 6.0 Harley Davidson TOYO RIZE RBP SCT MBRP S&

Balance Masters

truck22

2012 f250 sagging

ADcarbon

Balance Master

Mirror plug

Latest posts

S
F-250 & F-350 gear ratio question ?
- Latest: Smokin 6.0
- Yesterday at 6:47 PM
6.7 Tech & FAQ
D
‘10 6.4 rebuild
- Latest: Dieselnewb64
- Thursday at 5:23 PM
6.4 Tech & FAQ
S
F-350 Dually tire size
- Latest: Smokin 6.0
- Thursday at 5:14 PM
6.7 Tech & FAQ
Won’t start issues
- Latest: psduser1
- May 18, 2025
7.3 Tech & FAQ
Windshield washer fluid reservoir
- Latest: psduser1
- May 18, 2025
7.3 Tech & FAQ

Members online

No members online now.

Total: 297 (members: 0, guests: 297)

Top